CLEARSEAL is a water-based siliconate sealer designed for use as a water repeller on masonry surfaces. CLEARSEAL will assist in the prevention of moss and mould build-up. It can also be used as a pre-seal or pre-grout treatment for very porous surfaces such as terracotta or sandstone. This will greatly assist in the cleanup of excess grout. It is particularly well suited for use around swimming pools where water marks can be a problem.
For single leaf masonry brick walls spray application will reduce or prevent migration of water to inside of the wall.
DIRECTIONS FOR USE:
CLEARSEAL should be applied when the surface is clean and dry. Grease,
oil or dirt will interfere with the effectiveness of the sealing or pre-sealing process.
A lambswool applicator or garden sprayer will give best results
THIS PRODUCT IS A ONE COAT ONLY APPLICATION.
APPLYING TOO MUCH WILL RESULT IN A WHITE RESIDUE THAT IS DIFFICULT TO REMOVE.
Apply enough product to soak into the surface. Excess product in the form of pools should be removed immediately.
Allow 6 hours curing time – overnight if being used as a pre seal.
KEEP WELL AWAY FROM ALUMINIUM, STEEL AND TIMBER SURFACES.
Coverage is typically 12 m²/litre, but may vary from 8 m²/litre for very porous surfaces or tiles to 16 m²/litre for very dense surfaces or tiles.
Cleanup is done with water.
Block walls sealed with CLEARSEAL should be cleaned using Environex REFRESH or MAESTRO if there is a moss or mould problem.
RECOATING should be done every 2 years or when water repellency has